What‘s new in software v8.2 rev. 23889 (2025-10-23)

New functions:

• Last connections list on Connection page
• "Read/Write Configuration" for Mercedes CPC5, ACM3 (write price 20 tokens, check "Action" tab)
• "Read/Write Configuration" for Scania EMS S6/S7/EMD1 (write price 20 tokens, check "Action" tab)
• Z4 cable now works with Mercedes MP5 trucks
• "IVECO Bus" connection page
• Iveco bus CAMU memory operations via BSL (License Iveco CAMU and DC2U-CAMU cable)
• Iveco BC2 BDM memory operations (License Iveco BC2 and DC2U-BC2 cable)
• Disable AdBlue & DPF in ACM3
   
• Radar related parameters for Mercedes trucks:
  - Mercedes CGW "Radar" parameter (price 20 tokens)
  - Mercedes EBS "Active Brake Assist", "Radar" parameters (price 20 tokens)
   
• DPF and AdBlue related parameters for Mercedes MP5 trucks:
  - "ACM installed" parameter for Mercedes MP5 CGW (price 10 tokens)
  - "DPF enable", "AdBlue range" parameter for Mercedes MP5 INS (price 10 tokens)
  - "Control Unit List Teach-In" operation for Mercedes MP5 INS (price 10 tokens)
   
• Volvo EBS5 (Knorr-Bremse) BDM memory operations (License EBS updated and old DC2U-EBS-MAN Knorr are used)
• Scania COO7/COO8 "PIN read" now shows "Encryption code" too

• Scrolling bar is visible for all app areas
• Renamed connections MAN, Volvo/Renault "DC2 EBS2.3" -> "DC2 EBS2.3 (Knorr-Bremse)"

• Mercedes CPC5 GPT write (was "error 3.5" after 5% of progress)
• Mercedes FFR hardware class detection in BSL mode (always showed "hardware class 1" before)
• Mercedes EHZ EEPROM read/write via DC
• Mercedes Sprinter CR4 connect to some ECU variants (was "error 3.5" before)
• Scania COO "Unpair" and "Pair" buttons enable logic is correct now