New Software v8.5



What's new in software v8.5 (build 26254) 2026-08-10:
 
  • Cummins CM2350A memory operations via DC/JTAG (needs new DC2U-CM1 cable and License Cummins)
  • Scania EMS10/CEM1 memory operations via OBD/DC/JTAG (needs new DC2U-EMS10 cable and License Scania EMS10)
  • Scania EMS10/CEM1 configuration (Write price 20 tokens)
  • Volvo ACM JTAG memory operations (need new DC2U-ACM cable and License VOLVO ACM)
  • Mercedes MR A7, A8 (XC2287, XC2288) online unlock by DC/OBD (check "Action" tab, price 10 tokens) * if this MR was unlocked once with any VEI device. 32A and 32B not supported yet
  • MAN TCU/E300 (Voith) older hardware variant BSL memory operations
  • Iveco MF3 checksums
  • Mercedes/Freightliner CPC4 checksums

New ECU versions:
 
  • many MCM/ACM/CPC/INS diagnostic versions added
  • more DAF VECU versions detected properly
 
Changes:
 
  • for Mercedes MR (A8 type) we can connect via DC2 either as MCM (via CAN) or MR (via KLine)
  • during memory operations for Scania ECUs over OBD, loader is never touched (to prevent ECU brick)
  • Scania ECU FLASH write speed was optimized 
  • Scania EMS "Unpairing" operation via OBD available only if COO7/COO8 is present
  • suggested filename has more exact information now (missed hardware class were added)
  • added titles for Open/Save file dialogs (to see what memory type we are working with)

Fixed: 
 
  • BharatBenz "Detect control units" works properly now (was "ECU not supported" errors during faults operations before)
  • Mercedes CPC3 speed limit works for FLEET mode too
  • Mercedes V class CRV memory operation (was "error 3.8" during "Memory analyze")
  • Mercedes V class CR4 "Memory analyze" via GPT (was "unsupported version" error)
  • Mercedes V class CR4 "Read faults" works ok now (was not available before)
  • Mercedes INS teach-in action (was "error 3.5" in some cases)
  • MAN EBS2 (Wabco) BSL memory operations